← All guides Guide

Is my STL file ready to print? A quick check.

A model can look perfect on screen and still fail on the printer. These checks take a few minutes and prevent most surprises. If you are unsure about any of them, upload the file anyway: a reviewed print service checks them for you.

1. Units and size

STL files do not record units. A model drawn in inches and read as millimetres comes out about twenty-five times too small. Note the intended width, height and depth in millimetres when you upload, and compare them with what the slicer or the shop reports.

2. A closed, watertight mesh

The surface must enclose a volume with no holes, flipped faces or loose edges. Most slicers flag these as non-manifold errors, and many can repair small problems automatically. Large gaps usually mean going back to the modelling software.

3. Wall thickness

Walls thinner than about one millimetre are fragile on a typical filament printer, and features thinner than the nozzle may not print at all. Remember that thickness shrinks when you scale a model down.

4. Overhangs and supports

Surfaces that lean out past roughly forty-five degrees need support material underneath, which leaves marks where it is removed. Decide which faces must stay clean and say so, so the part can be oriented to protect them.

5. Small text and fine detail

Raised or engraved lettering needs strokes wide enough to print. Detail that looks sharp on screen can vanish at small sizes.

6. Fit and moving parts

Parts that slide or snap together need clearance, typically a few tenths of a millimetre, and the right amount depends on the printer and material. Say which dimensions are critical and what the part mates with.

7. Does it fit the printer?

Every printer has a maximum build size. Larger models can be scaled down or split into pieces that are joined after printing.

Rights to print

Only send files you created or are licensed to have printed. Many free models are shared for personal use only.

Questions before you start

Frequently asked questions

Which file format is best?

STL and 3MF are the most widely accepted. 3MF also stores units, colours and multiple parts, so it is the safer choice when you have it.

Can you fix a broken file?

Small mesh errors can usually be repaired. A model that needs redesign is quoted as design work.

Can I print just one?

Yes. A single sample is the best way to check fit before ordering more.

Toronto, GTA & beyond

Custom 3D printing, with help from the first idea.

Based in Toronto, Ontario. Custom 3D printing for Mississauga and the Greater Toronto Area, with shipping across Canada and the US.

No modelling experience needed. Share your requirements and target date; we confirm feasibility, costs and delivery timing for your project.

Tell us what you need
Get a free quote